download
1. Open the trunk lid, and remove the rear bumper (four clips and two self-tapping screws). 2 SELF- TAPPING SCREWS 4 CLIPS 2. Position the template on the left side of the rear bumper by aligning them as shown. Using a pushpin, pierce the rear bumper as indicated by the arrow on the template. REAR BUMPER PUSHPIN CENTER OF BUMPER TEMPLATE 3. Remove the template. While wearing eye protection, drill a 10 mm hole at each of the seven pierced points on the rear bumper. First drill with a 3 mm drill bit, and finish with a 10 mm drill bit. DRILL (First drill with a 3 mm drill bit and finish with a 10 mm drill bit.) REAR BUMPER 7 PIERCED POINTS Cut out.

4. Draw the lines that connect the 10 mm holes in the rear bumper as shown, and cut off the rear bumper along the lines you just made. 5. Flip the template, and repeat steps 2 through 4 on the right side of the rear bumper. 6. Slide the two spring nuts onto the recesses at both ends of the rear bumper. Position the rear under spoiler on the rear bumper, and install the two self-tapping screws. REAR BUMPER REAR UNDER SPOILER PUSHPIN (There must be no clearance between the rear under spoiler and rear bumper.) SPRING NUT RECESS SELF-TAPPING SCREW 7. Using a pushpin, mark both ends of the rear bumper at the upper hole position of the rear under spoiler. There must be no clearance between the rear under spoiler and rear bumper. Remove the rear under spoiler.